Author Topic: Ibara Black Label (4 button set-up)  (Read 1370 times)

jpj

  • Guest
  • Trade Count: (0)
Ibara Black Label (4 button set-up)
« on: December 18, 2007, 06:20:03 PM »
what are the four buttons used for in this game, and how do you go about setting it up for a jamma 3-button super-gun setup?

cheers in advance   :)

Offline Sperrfeuer

  • Trade Count: (0)
  • Member
  • Posts: 92
Ibara Black Label (4 button set-up)
« Reply #1 on: December 19, 2007, 12:42:15 AM »
shot-bomb-autofire-change weapon IIRC

for 3 button setup you would need shot-bomb-change weapon  and put the autofire on button 4 IMO but i'm not sure if you can do this (when i have some time i can check it....)

or buy a cab or a better supergun... if you have the money for a 800$ PCB you should also have the money for the right tools to play it ;)

Offline EOJ

  • Administrator
  • Trade Count: (34)
  • Member
  • Posts: 7019
Ibara Black Label (4 button set-up)
« Reply #2 on: December 19, 2007, 11:23:32 AM »
You can't change the button config in BL. Button 4 is essential. If the 4th button doesn't work with your supergun then you need a new JAMMA harness wired for 4 buttons instead of 3.
My score archive
twitter: cavexstg
XBL gamertag: eojx9999

Offline rtw

  • Trade Count: (1)
  • Member
  • Posts: 379
    • http://www.world-of-arcades.net
Ibara Black Label (4 button set-up)
« Reply #3 on: December 27, 2007, 04:09:14 AM »
Or you could try to run a wire from JAMMA pin 25 and connect it
to pin 17 (1P Start). In this manner you would have to to hit 1P Start
to change the weapon.

rtw
The future of ST-V rests upon our work and your work

Offline SuperPang

  • Moderator
  • Trade Count: (4)
  • Member
  • Posts: 625
    • Arcade Otaku
Ibara Black Label (4 button set-up)
« Reply #4 on: December 28, 2007, 08:40:33 AM »
I always get asked why my vert cabs are set up like

123
4XX

tis purely for two games